A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
-
Insert a steel wire or pin ( approx. 1.5 mm) in hole - 1 - as far as it will go, at the same time pulling lock cylinder - 2- with reader coil out of
steering lock housing - 3 -.
CAUTION: Steering lock must not be operated without the lock cylinder, otherwise it will lock completely. The entire steering lock must then be
replaced.
NOTE: When replacing lock cylinder, note immobilizer reader coil specifications.
Installing
Install in reverse order of removal, noting the following:
-
Insert spare ignition key into lock cylinder and turn to ignition "on" position.
-
Re-insert steel wire/pin -1 - in hole on end face as far as it will go.
-
Insert lock cylinder - 2 - with reader coil in steering lock housing - 3 -.
-
Then pull out steel wire and press in lock cylinder firmly until catch engages audibly.
-
Connect electrical connector on immobilizer reader coil.
Vehicles with automatic transmission:
-
Turn ignition key to "Ignition ON" position.
-
Slide locking cable - 2 - into ignition lock housing until it engages audibly.