A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Brake Light Switch: Service and Repair
Brake light switch, removing and installing
Note:
^
The brake light switch must be removed in order to adjust it.
^
To ensure a secure fit, the switch may only be installed once.
Removing
-
Disconnect electrical connector.
-
Turn brake light switch counter-clockwise 45° to remove.
Installing
Installation is performed in reverse sequence; note the following:
-
Pull out brake light switch plunger as far as it will go - arrow -.
-
Install retainer tabs - 1 - and - 2 - on switch into recesses of installation hole.
-
Remove drivers storage compartment.
Note:
^
When installing, brake pedal must not be pressed.
^
The plunger adjusts itself automatically when the brake light switch is inserted.
-
Guide switch through installation hole, press against pedal and secure by turning 45° clockwise.
After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).