A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Note:
^
Do not damage drive axle boot.
^
Make sure the two lever arms of the puller are parallel when maximum force is exerted.
-
Position Engine/transmission jack V.A.G 1383 A with suitable wooden block under subframe and apply slight pressure upward.
-
Remove hex bolts - 2 - and - 3 - on both sides.
-
Lower subframe slightly with Engine/transmission jack V.A.G 1383 A.
Take care not to damage surface of brake lines and undercoating.
-
Remove hexagon bolt - 1 -.
-
Remove guide link.
Installing
Note:
^
Bonded rubber bushes can only be turned to a limited extent. The mountings of the suspension links must therefore only be tightened when the
suspension is in the curb weight position.
-
Tighten nut on joint pin
-
Tighten hex bolt - 2 -.
-
Tighten hex bolt - 3 -.
-
Fasten brake caliper (if detached).
-
Install wheels and tighten.