A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Clutch Disc: Service and Repair
Conventional Clutch, Servicing
Conventional clutch, servicing, 02X, 6 Spd. M/T AWD
^
Please refer to notes.
^
Remove transmission to work on clutch.
1 - Flywheel/dual mass flywheel
^
Ensure that dowel pins fit tightly
^
Contact surface for clutch lining must be free of grooves, oil and grease
^
Removing and installing
2 - Bolt for flywheel
^
Always replace
^
Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^
Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn
3 - Clutch plate
^
Installation position: Clutch lining must make full contact with flywheel
^
Marking Getriebeseite (transmission side), if provided, faces pressure plate/transmission.
^
Coil springs (damper assembly) point toward pressure plate and transmission
^
Centralize
^
Clutch plate diameter
4 - Pressure plate
^
Removing and installing
^
Check ends of diaphragm spring
^
Check spring connection and rivets
^
Check wire ring
5 - Bolt - 22 Nm
^
Loosen and tighten gradually in several stages and in diagonal sequence
6 - Needle bearing
^
Removing and installing