A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
/Page-2913003.png)
10 - Ball head stud
^
Lubricate with MoS2 grease.
11 - Transmission
12 - Slave cylinder
^
Removing and installing
^
Do not operate clutch pedal after slave cylinder has been removed.
^
Follow correct procedure when bleeding.
^
Tighten bleeder valve to 4.5 Nm.
^
When installing push in until the securing bolt can be installed.
13 - Hex socket head bolt - 23 Nm
^
Self-locking
^
Replace
14 - Bracket
^
For line/hose assembly
^
Bolt to transmission with slave cylinder
15 - Operating rod
^
Lubricate end of operating rod with copper grease Z381351TE.
Checking and servicing release bearing with glued plastic ring
Identification: inner side of plastic ring has three tabs - arrows -.
The plastic ring - arrows - may come loose from the release bearing when the transmission or release bearing is removed. The release bearing does not
have to be replaced if this happens.
-
Before installing the transmission, glue loose plastic ring back onto bearing with adhesive AMV195KD101.
Three square tabs - arrows - of the plastic ring engage in recesses of the bearing ring.
^
The release bearing must be replaced if the groove worn on the plastic ring is deeper than 0.8 mm.
Checking release bearing with mechanically attached plastic ring
Identification: retaining tabs around plastic ring - arrows -.
^
The release bearing must be replaced if the plastic ring - 1 - has come loose.
^
The release bearing - 3 - must be replaced if the groove - arrow2 - worn on the plastic ring - 1 - is deeper than 0.8 mm.
