A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
^
Always replace
^
Insert in ring groove on shaft before installation (not visible on installed joint)
4 - Clamp
^
Always replace
5 - Boot for outer CV joint
^
Check for tears and chafing, replace if necessary
^
Check outer constant velocity joint, if boot is damaged
^
To equalize pressure, lift boot before tensioning clamp.
^
Sealing surfaces must be free of grease when assembling.
6 - Drive axle
^
For correct version see Parts catalog
7 - Cover
^
Always replace
8 - Gasket
^
Always replace
9 - Circlip
^
Always replace
^
For correct version see Parts catalog
^
Insert in groove on shaft
10 - Inner constant velocity joint
^
Outside diameter: 100 mm
^
Replace only as a complete assembly
^
Removing
^
Installing
^
Greasing
^
Bonding surfaces must be free of oil and grease
^
Checking
11 - Bracket plate
12 - Socket-head bolt
^
For correct version see Parts catalog
13 - CV joint boot with cap
^
Check inner constant velocity joint if boot is damaged
^
Check for tears and chafing
^
Replace only as a complete assembly
^
Removing
^
Installing
^
Sealing surfaces (drive axle boot and cap) must be free from grease when assembling