A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
/Page-2981005.png)
Pressing on inner constant velocity joint
-
Press on joint as far as stop.
Use Sleeve-press tool VW 522.
-
Engage circlip.
Note:
^
Chamfer on internal diameter of ball hub (splines) must face drive axle.
Coating sealing surface of cover and cap with D 454 300 A2
-
Apply sealant on clean surface of cover and cap (hatched area). Route continuous bead of sealant (2 to 3 mm diameter) around inside of holes -
arrow -.
-
Align cover and cap with bolt holes and drive or press onto joint.
-
Remove excess sealant immediately as it is pressed out.
