A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Rear Bumper Reinforcement: Service and Repair
Impact Member Without Trailer Hitch
Rear Bumper
Impact Member without Trailer Hitch
Removing
-
Remove the rear bumper cover. Refer to => [ Rear Bumper Cover ]. See: Service and Repair/Rear Bumper Cover
-
Disconnect the electrical connector on the radio frequency controlled clock receiver (J489).
‹› If the impact bar is replaced - 3 -, remove the radio frequency controlled clock receiver (J489).
-
Remove the bolts - 1 - by counterholding the nuts - 2 -.
-
Remove the impact bar - 3 -.
Installation
‹› Tightening specifications, refer to => [ Impact Bar Assembly Overview ] See: Service and Repair.
Installation is reverse of removal, but note the following:
-
Install the rear bumper cover. Refer to => [ Rear Bumper Cover ]. See: Service and Repair/Rear Bumper Cover