A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Front Subframe: Service and Repair
Subframe
Subframe
Special tools, testers and auxiliary items required
‹› Engine support bridge (10-222 A)
‹› Engine support supplement set (T40093), needed depending on the engine.
‹› Engine-/transmission jack (V.A.G 1383 A )
‹› Mount (T10149)
‹› Tensioning strap (T10038)
Removing
-
Remove wheels.
-
Remove the left and right wheel housing liner.
-
Remove noise insulation.
-
Remove the crossbrace. Refer to => [ Subframe Crossbrace ] See: Subframe Crossbrace.
-
Remove the right and left subframe shield if applicable. Refer to => [ Subframe Shield ] See: Subframe Shield.
-
Remove the stabilizer bar. Refer to => [ Stabilizer Bar ] See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Front
Suspension/Stabilizer Bar.
-
Remove the vehicle level sensor, if applicable. Refer to => [ Level Control System Sensor ] See: Sensors and Switches/Sensors and Switches -
Steering and Suspension/Sensors and Switches - Suspension/Suspension Control Pressure Sensor/Switch/Service and Repair/Front
Suspension/Level Control System Sensor.
-
Secure the left and right wheel housing liner using a ( T10038) as shown in the illustration.