A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Scuff Plate: Service and Repair
Outer Sill Panel Strip
Moldings and Trim
Outer Sill Panel Strip
‹› The sill panel is secured to the sill panel using adhesive strips.
‹› It is not possible to remove without destroying.
1
Door Seal
2
Rear Sill Panel Trim
‹› Removing
-
Heat the door sill molding using a hot air gun and pull the molding upward and off.
‹› Installing
-
The side member must be free of dirt and grease in the adhesive area.
-
Heat the adhesive surface to approximately 40 °C with a heat gun.
-
Remove protective film from adhesive tape.
-
Insert the sill panel trim with the centering pins in the side member and press it on firmly in stages from front to back.