A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Trim Panel: Service and Repair
Upper Rear Lid Trim
Rear Lid Trim, Wagon
Upper Rear Lid Trim
Special tools, testers and auxiliary items required
‹› Pry lever (80 - 200)
Removing
-
Remove the lower rear lid trim. Refer to => [ Lower Rear Lid Trim ] See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Lower Rear Lid Trim.
-
First unclip the upper side trim - 1 - using the pry lever (80 - 200) from the rear lid - arrows A -.
-
Then unclip the upper trim using the pry lever ( 80 - 200) from the rear lid - arrows B - and remove it.
Installation
Installation is performed in reverse order of removal, noting the following:
‹› If the trim clamps - 2 - remain in the rear lid mounting points, remove them and insert them in the trim.
‹› Check clamps for damage or deformation, replace if necessary.