A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-1495005.png)
-
Install brake hose and electrical wire into the bracket on the stub axle carrier.
‹› Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of
the bracket on its own.
-
Install wheels.
-
Lower vehicle.
-
Check brake fluid level and fill if necessary.
-
Switch on ignition
Display on vehicle diagnostic, test and information system :
‹› The request to enter a display group number appears in display field - 1 -.
‹› An entry keypad is shown in display field - 2 -.
-
Using the entry keypad, enter in display field - 2 - the " 006" for the display group number and confirm by pressing the " Q button". (guide pistons
together).
-
To exit the entry template, press the green Arrow button at the lower left.
‹› DTC memory interrogated, errors shown corrected and DTC memory erased.
-
Disconnect vehicle diagnostic, test and information system (VAS 5051B) or (VAS 5052) from the 16-pin Data Link Connector (DLC) in the
vehicle with ignition switched off.
