A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
4
Bearing shell
‹› Without lubricating groove
‹› Do not interchange used bearing shells (mark)
‹› The crankshaft bearing shells in the bearing caps are only available as a replacement part with a "yellow" color marking.
5
Bolt
‹› Replace
‹› Tightening order => [ Crankshaft, tightening sequence ]
6
Bearing cap
‹› Bearing cap 1: Belt pulley side
‹› Retaining tabs of bearing shells and cylinder block/bearing caps must lie above one another
7
Bolt
‹› 10 Nm plus an additional 90° turn
‹› Replace
‹› Replace sensor wheel every time bolts are loosened, refer to => [ Sensor Wheel ] See: Crankshaft Gear/Sprocket/Service and Repair
8
Sensor wheel
‹› For Engine Speed (RPM) Sensor (G28)
‹› Only possible to install in one position - Bores are offset
‹› Replace sensor wheel every time bolts are loosened
‹› Removing and installing, refer to => [ Sensor Wheel ] See: Crankshaft Gear/Sprocket/Service and Repair
9
Thrust washers
‹› For bearing 3
10
Bolt
‹› Replace
‹› Tightening order => [ Crankshaft, tightening sequence ]
Crankshaft, tightening sequence