A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Engine Accessory Bracket: Description and Operation
A/C Compressor
Compressor Bracket
‹› You can remove and reinstall the compressor on vehicles with 4 cylinders engine and 6 cylinder. The TDI engine can be removed and installed at
the bracket without opening the refrigerant lines.
‹› On vehicles with 6 cylinder and 8 cylinder On the FSI engine, the compressor can disconnected and removed from the bracket only if the
refrigerant circuit is open. Refer to => [ Compressor on Bracket ] See: Heating and Air Conditioning/Compressor HVAC/Service and Repair.
‹› The following describes the removing and installing of the compressor for a vehicle with a 4 cylinder TDI engine and a 6 cylinder TDI engine with
a "Denso"- compressor, type "6 SEU 14". On vehicles with a 4 cylinder On vehicles with a different engine or a different compressor (depending
on engine, additional assemblies may need to be removed or loosened).
‹› Do not discharge the refrigerant circuit to remove the bracket, do not remove refrigerant hoses and lines from compressor.
‹› Do not unfasten refrigerant pipes and corresponding clamps.
‹› Secure compressor after removal with a wire, e.g. on the vehicle, do not allow it to hang by the refrigerant lines.
‹› Before removing, mark direction of operation of ribbed belt with chalk or felt-tipped pen. Running a used belt in the opposite direction could
destroy it.
‹› Different compressors may be installed depending on engine and country variant.
‹› Compressor, 4 cylinder, Removing from and Installing on Bracket. Refer to=> [ A/C Compressor ] See: Heating and Air Conditioning/Compressor
HVAC/Service and Repair
‹› Compressor, 6 cylinder, TDI, Removing from and Installing on Bracket. Refer to=> [ A/C Compressor ] See: Heating and Air
Conditioning/Compressor HVAC/Service and Repair