A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Engine Mount: Service and Repair
Engine Mount
Special tools, testers and auxiliary items required
‹› Engine Support Bridge (10 - 222 A)
Removing
Removing the engine mount was described on the left engine mount.
-
Support the engine. Refer to => [ Engine, Support with Engine Support Bridge ] See: Service and Repair/Removal and Replacement/Engine,
Support with Engine Support Bridge.
-
Remove front wheels.
-
Remove noise insulation.
-
Remove wheel housing liner.
-
Disconnect and free up the connector - 3 - on the Left Electro-Hydraulic Engine Mount Solenoid Valve (N144).
-
Remove engine mount bolts - 1, 4 and 5 -.
-
Move engine mount retaining plate - 2 - to the side.
-
Remove engine mount.
Installing
Installation is in reverse order of removal, note the following:
Tightening specifications. Refer to => [ Subframe Assembly Overview ] See: Service and Repair/Removal and Replacement/Subframe Assembly
Overview
‹› Replace bolts which have been tightened to an additional torque.
-
Install the noise insulation and the wheel housing liners.