A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-2178003.png)
-
Insert the guide - D - (on the bracket - C - with the control motor) into the bracket - E - (on the A/C).
-
Push the bracket - C - opposite the direction of the arrow to the toothed segment - B - and insert the pin - A - (on the control motor bracket) into
the toothed segment - B - (temperature door shaft).
‹› The control motor and the toothed gear - C - do not have a stop; therefore the toothed gear - C - can be joined to the toothed segment - B -
(temperature door shaft) in any position.
-
Remove the screws - C - and - E -.
-
Connect the connector - D -.
-
Install the wiring harness so that it cannot come in contact with any moving parts (e.g. the actuating arm).
-
Install the removed parts in the opposite order.
-
Perform a basic setting and the output Diagnostic Test Mode (DTM).on the A/C system. Refer to Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.