A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Compressor Pulley: Description and Operation
Compressor Drive Shaft
Compressor Drive Shaft
Remove the driveshaft
-
Remove the compressor, refer to=> [ A/C Compressor ] See: Service and Repair
-
Remove the boot - A -
-
Remove driveshaft - B - from splines of drive pinion - C -
‹› Currently, the boot - A - is secured against slipping by a clamp on flange of drive toothed gear - C - of engine.
Install the driveshaft
Installation is carried out in the reverse order, when doing this note the following:
-
Check driveshaft - B -, splines must show no traces of wear and must be seated free of play in splines of drive wheel - C -.
-
Before installing, coat the driveshaft splines - B - for example with Grease (G 000 100).
-
Insert driveshaft - B - before installing compressor and slide it into drive wheel - C - up to stop.
-
After installing compressor, check installation position of boot - A -.
The boot - E - is secured against slipping by the clamp on the power steering pump flange.