A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Fuse Block: Service and Repair
Passenger Side A-Pillar 6-Pin Connector Station
Passenger Side A-Pillar 6-Pin Connector Station
Observe notes on contact corrosion => [ Contact Corrosion ] See: Wiring Harness/Service Precautions.
Removing
-
With ignition switched off, disconnect battery Ground (GND) cable => [ Battery, Disconnecting and Connecting ] See: Starting and
Charging/Battery/Service and Repair/Removal and Replacement/Battery.
-
Remove lower right A-pillar trim.
-
Press retaining clip in direction of - arrow - and disengage the connector station - 1 - at the A-pillar.
-
Unclip fuse panel - 2 - at the connector station.
-
Remove relay and control modules.