A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Oxygen Sensor: Testing and Inspection
Oxygen Sensor O2S Behind Three Way Catalytic Converter, Checking
Oxygen Sensor O2S Behind Three Way Catalytic Converter, Checking
Observe all safety precautions: => [ Safety Precautions ] See: Computers and Control Systems/Service Precautions/Safety Precautions
View clean working conditions: => [ Clean Working Conditions ] See: Computers and Control Systems/Service Precautions/Clean Working
Conditions
For wiring diagrams, component locations, and connector views, Refer to the applicable wiring diagram.
‹› Vehicle must be raised before the electrical connector for the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) is
accessible.
‹› When servicing terminals 3 and 4 in the electrical harness connector of the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC)
(G130), use only gold-plated terminals.
Special tools, testers and auxiliary items required
‹› Generic scan tool
‹› multimeter.
‹› Wiring diagram.
Test requirements
‹› The Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) fuse Ok.
‹› Oxygen Sensor O2S Behind Three Way Catalytic Converter Heater ( Z29) OK. Refer to => [ Oxygen Sensor O2S 1 Heater Before Catalytic
Converter, Checking ].
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Vehicles with automatic transmission, selector lever in position " P" or "N".
‹› A/C switched off.
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Exhaust system between catalytic converter and cylinder head properly sealed.
‹› Coolant Temperature at least 80 °C.