A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Connect the wiring harness connectors - 3 - to the control module - 8 -.
-
Carefully slide the wiring harness clip connection - 3 - into the bracket - 4 -.
-
Insert the control module with the bracket.
-
Connect the ground wire - 2 - to the threaded pin and tighten the nuts - 1 - to 6 Nm.
-
Tighten nuts - 7 - to 6 Nm.
-
The system must be calibrated if the active steering control module is replaced (J792). Refer to => [ Dynamic Steering Calibration Procedure ]
See: Maintenance/Alignment/Service and Repair/Procedures/Dynamic Steering Calibration Procedure.
Tightening Specifications