A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Remove the nuts - 1 - and the cover - 2 -.
-
Separate connector - 2 -.
-
Remove nut - 3 -.
-
Remove the bolt - 1 -.
-
Remove level control system sensor - 4 -.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› Only sensors of the same version may be installed.
Tightening specifications: Refer to => [ Track Control Arm, Ball Joint, Guide Link and Level Control System
Sensor Assembly Overview ] See: Track Control Arm, Ball Joint, Guide Link and Level Control System Sensor Assembly Overview.
Guide the retaining hook on the sensor bracket into the subframe.
The sensor lever must point toward the back.
After loosening, check basic setting of headlamp adjustment. Refer to => [ Headlamps, Adjusting ] See: Lighting and Horns/Headlamp/Adjustments
-
If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the
control position must be reprogrammed. Refer to => [ Control Position, Programing with VAS 5051B ] See: Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection.