A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
‹› Mark the installation location of the subframe - A - to - D -, for example, using a felt-tip pen.
-
Remove the bolts - 1 - through - 8 - and remove the subframe.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Tightening specifications: Refer to => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Shield
Assembly Overview ] See: Stabilizer Bar/Service and Repair/Front Suspension/Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe
Shield Assembly Overview.
Tightening specifications: Refer to => [ Mounting Bracket, Shock Absorber Fork, Upper Control Arm and Tower
Brace Assembly Overview ] See: Suspension Control ( Automatic - Electronic )/Air Spring/Service and Repair/Mounting Bracket, Shock Absorber Fork,
Upper Control Arm and Tower Brace Assembly Overview.
Tightening specifications: Refer to => [ Track Control Arm, Ball Joint, Guide Link and Level Control System
Sensor Assembly Overview ] See: Sensors and Switches - Suspension/Suspension Control Pressure Sensor/Switch/Service and Repair/Front
Suspension/Track Control Arm, Ball Joint, Guide Link and Level Control System Sensor Assembly Overview.
Tightening specifications: Refer to => [ Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview ] See: Wheel Bearing/Service and
Repair/Removal and Replacement/Front Suspension/Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview.
Subframe Bolting Procedure: