A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Rear Subframe Mount: Service and Repair
Rear Rubber Bonded Bushing For Rear Final Drive
Rear Rubber Bonded Bushing for Rear Final Drive
Special tools, testers and auxiliary items required
‹› Assembly tool (3301)
‹› Assembly tool (3346)
‹› Assembly tool (T40185)
Removing
-
Subframe with attachments, removing and installing, refer to => [ Subframe with Attachments ] See: Rear Subframe/Service and Repair/Subframe
With Attachments
-
Remove rear final drive.
-
Install tools at subframe as shown in illustration.
1. Spindle (3346/2)
2. Nut (3346/3)
3. (3301)
4. Tube (T40185/2). Side "A" must face the subframe.
5. Subframe
6. Tube (T40185/1). Side "A" must face the subframe.
7. (3346)
-
Pull bearing out of subframe.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
-
Note the installation position for the rubber bonded bushing.
-
The arrows on the back of the rubber bonded bushing must point up or down.