A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Remove nut - 3 -.
-
Remove the bolt - 1 - and the spacer tube - 2 -.
‹› Axle alignment is necessary if the nut - 3 - is loosened or the bolt - 1 - is removed.
-
Tip the wheel bearing housing to the side and remove the drive axle from it.
-
Remove wheel bearing housing.
Wheel Bearing Unit, Removing. refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Tightening specifications: Refer to => [ Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber, Assembly Overview ] See:
Service and Repair/Removal and Replacement/Rear Suspension
‹› Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension screws when vehicle is in curb weight or control position.
‹› Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight
Position ] See: Procedures/Rear Suspension.
-
Install wheel bearing housing.
-
Insert the bolt - 1 - with the spacer tube - 2 - and install the nut - 3 - loosely.