A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
![background image](/audi/a4_quattro_wagon/l4-2.0l_turbo_(caeb)/Page-1392003.png)
-
Make sure that the markings on the driveshaft flange - arrow A - and the rear final drive - arrow B - are aligned.
Driveshaft tightening sequence:
-
First tighten the bolt next to the colored marking - 1 - to 20 Nm.
‹› By doing this, the CV joint is pushed slightly to the opposite side and imbalance is avoided.
-
Then tighten the rest of the driveshaft bolts - 1 - on the rear final drive in stages to 20 Nm.
-
Tighten the 6 bolts to the torque specification => [ (Item 5) Bolt ] See: Driveshaft Assembly Overview.
‹› Use the counterhold tool (T10172) with the adapters (T10172/5) to do this.
-
Install rear section of exhaust system.