A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Drive/Propeller Shaft: Service and Repair
Driveshaft
Driveshaft
Special tools, testers and auxiliary items required
‹› Alignment Fixture (3139)
‹› Counterhold Tool (T10172) with Adapters (T10172/5)
‹› Engine/Transmission Jack (V.A.G 1383 A) with Universal Support (V.A.G 1359/2)
‹› High Temperature Grease (G 000 633)
Remove the driveshaft.
‹› See notes. Refer to => [ Driveshaft Assembly Overview ] See: Driveshaft Assembly Overview.
‹› A twin pillar vehicle hoist should be used when working on the driveshaft.
‹› Flex joint in front exhaust pipe must not be bent more than 10°, otherwise it may be damaged.
-
Loosen the clamp(s) - arrows - and separate the exhaust system.
-
Tie up the exhaust pipe(s) to the floor panel.
-
Remove the rear section of exhaust system - 2 -.