A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Drive/Propeller Shaft: Service and Repair
Driveshaft, Removing and Installing on Transmission
Driveshaft, Removing and Installing on Transmission
Special tools, testers and auxiliary items required
‹› Counterhold Tool (T10172) with Adapters (T10172/5)
‹› High Temperature Grease (G 000 633)
Remove driveshaft.
‹› See notes. Refer to => [ Driveshaft Assembly Overview ] See: Driveshaft Assembly Overview.
‹› A twin pillar vehicle hoist should be used when working on the driveshaft.
‹› Flex joint in front exhaust pipe must not be bent more than 10°, otherwise it may be damaged.
-
Loosen the clamping sleeves - 1 - and - 2 - and disconnect the exhaust system.
-
Tie up the exhaust pipe(s) to the floor panel.
-
Remove the heat shield - A - from the transmission - arrows -, if applicable.
-
Remove the bolts that connect the driveshaft to the transmission by counterholding them with the Counterholder (T10172) and (T10172/5).