A4 Quattro Wagon V6-2.8L (AHA) (1998)
Trunk / Liftgate Hinge: Service and Repair
Rear Lid Hinge, Removing And Installing
-
Remove screws - 2 - and cover - 1 - for hinge.
-
To install, first center cover - 1 - in notches (arrow) in roof flange and then tighten screws - 2 - to 2.5 Nm (22 in.lb).
-
Remove rear roof molding trim.
-
Remove hex bolt - 5 -.
-
Remove hex bolt - 1 -.
-
Replace seal - 3 - during installation.
-
Tighten hex bolt and bolt to 21 Nm (15 ft.lb).