A4 Quattro Wagon V6-2.8L (AHA) (1998)
Throttle Position Sensor: Testing and Inspection
Throttle Position (TP) Sensor, Checking
NOTE: The Throttle Position (TP) sensor -G69- is located inside the throttle valve control module -J338-.
Test conditions
-
Throttle valve in closed throttle position; if necessary adjust accelerator pedal cable
-
Cruise control adjustment OK
-
Power supply for throttle valve control module OK; Refer to "Throttle Valve Control Module Power Supply, Checking" See: Computers and
Control Systems/Electronic Throttle Control Module/Testing and Inspection
Checking
-
Connect VAG1551 or VAG1552 scan tool and press buttons -0- and -1-to insert "Engine Electronics" address word 01 (with ignition switched;
engine not running). Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG 1551/1552 Scan Tool" See:
Computers and Control Systems/Testing and Inspection
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" function 08, and press -Q- button to confirm input.
Indicated on display
Read Measuring Value Block
HELP
Input display group number XXX
-
Open throttle valve slowly while monitoring degree (°) value in display field 3.
Value must increase uniformly over the entire range.
-
Press -> button.
-
Press buttons -0-, -0- and -3- to input display group number 3 (003), and press -Q- button to confirm input.
Indicated on display (1-4 = display fields)
Read Measuring Value Block 3
->
1 2 3 4
-
Compare display with specified values for throttle angle, (display field 3):
Display Group 3
-
Press buttons -0- and -6- to select "End Output" function 06, and press -Q- button to confirm input.
-
Switch ignition off.