A4 Quattro Wagon V6-2.8L (AHA) (1998)
![background image](/audi/a4_quattro_wagon/v6-2.8l_(aha)/Page-5593002.png)
Fig. 1 Pressing bonded rubber bushings out of upper control arm
If VW41 6B tube, 37 mm dia. becomes canted while pressing out, relieve pressure and start over.
CAUTION: Be careful not to the surface of the upper control arm.
Fig. 2 Pressing bonded rubber bushing out of upper control arm
Note: 41-501 tubular section must be exactly in the correct position.
Fig. 3 Pressing bonded rubber bushings into upper control arm
-
Position bonded rubber bushing perpendicular to upper control arm.
-
Press bushing fully in up to stop.