A4 Quattro Wagon V6-3.0L (AVK) (2002)
-
Remove cable -arrow- from console
-
Unscrew bolt -3-
-
Loosen hex bolts -2- until subframe can be removed.
Installing
Note: Always replace nuts and bolts.
-
Insert subframe and install hex bolts -5- and -6-.
-
Install hex bolt for securing suspension strut to track control link
-
Insert track control link and guide link in subframe.
Before tightening subframe, locate it in body using special tool 3393.
-
Hole -1-, hole -2- of subframe and hole -3- of aluminum console must all be aligned on both sides.
Note: This locating process is only a substitute for subsequent wheel alignment if:
^
Only the subframe has been removed and installed.
^
Holes -1- and -2- matched before repair.
-
Install hex bolts -1- and -2-.
-
Apply anti-corrosion agent to hole in body for holding special tool 3393.