A4 Quattro Wagon V6-3.0L (AVK) (2002)
NOTE: A passenger seat backrest is shown in the illustration.
-
Remove bolt from motor for backrest adjustment.
-
Pry out spring washer - 5 - on side of backrest motor with a screwdriver (magnified area of illustration - B -.)
-
Tap shaft - 4 - through the side of the backrest frame using a hammer and drift punch.
-
Pull out shaft - 4 - just far enough out of backrest frame - 1 - until motor for backrest adjustment comes out.
-
Installing:
-
Adapt the splines of new motor for backrest adjustment.
-
Slide shaft - 4 - through motor for backrest adjustment and through backrest frame - 1 -
-
Set seat aside.
-
Place a wood block - 2 - beneath shaft - 4 - (illustration - A -) on opposite side of motor for backrest adjustment.
-
Tap spring washer - 5 - onto shaft - 4 - using a socket wrench 11 mm insert - 3 - (illustration - C -).
-
Install screw on backrest adjustment motor and connect connector.
Further installation is performed in the reverse order of removal.
For seats with seat memory:
-
After installing seat, perform a basic setting for backrest or seat.