A4 Quattro Wagon V6-3.0L (AVK) (2002)
-
Release the locking clip from below -1- and pull it out in the direction of the arrow.
-
Remove hydraulic control unit.
Installing
Pay special attention to the following on installation:
^
Only remove sealing plugs on new hydraulic control unit when the corresponding brake line is about to be installed.
^
If the sealing plugs are removed too early, brake fluid can escape, it can then no longer be guaranteed that the unit is sufficiently filled or
adequately bled.
-
Bleeding brake system, Refer to Brake Bleeding, Service and Repair
-
Enter radio code.
See Caution for connecting Telematics battery
-
Connect battery ground strap.