A4 Quattro Wagon V6-3.0L (AVK) (2002)
-
Make sure centering sleeve -A- is correctly seated before installing.
-
Install gasket
-
Set on cover i.e. intermediate flange for front final drive.
Note: If installing the intermediate flange to the output shaft carelessly, the sealing lips of the sealing ring can be damaged.
Tightening sequence:
^
1. Stage: Tighten bolts -1- to -3- by hand
Note: When tightening bolts by hand, make sure the housing gap between cover and transmission housing decreases evenly around
circumference.
^
2. Stage: Tighten bolts -1- to -14- in specified sequence to tightening torque Check ATF level and top off. Install center differential.
Tightening torques