A4 Quattro Wagon V6-3.0L (AVK) (2002)
Installation is carried out in the reverse order, when doing this note the following:
Note:
^
Do not allow brake fluid to come into contact with the transmission. If necessary, clean the transmission housing.
^
If the clutch slave cylinder is inserted off-line there is a danger that the push rod will be guided past the clutch release lever.
^
To facilitate installation, engage 6th gear (6-speed transmission) or 4th gear (5-speed transmission) before fitting the slave cylinder.
^
Pre-tension the clutch slave cylinder far enough for the securing bolt to be easily inserted.
^
Always replace securing bolt.
-
Coat area - a - of collar with Lithium grease G 052 150 A2 before mounting the slave cylinder into the transmission housing.
-
Lightly coat contact surface for plunger to clutch release lever using copper grease, e.g. Z 381 351 TE.
-
Insert clutch slave cylinder into mounting hole in transmission housing, keeping it as far as possible in line with direction of operation of push rod,
then tighten bolt (arrow).
-
To connect line to slave cylinder, press in retaining clip - A - as far as it will go.
-
Push line into slave cylinder until it engages audibly.
-
Install transmission support and transmission mounting.
-
Bleed clutch system
Tightening torques