A4 Quattro Wagon V6-3.0L (AVK) (2002)
Clutch Release Bearing: Service and Repair
5 SPD. M/T 01A AWD
Clutch release mechanism components (on transmission), servicing
1 - Transmission
2 - Ball pivot, 25 Nm
^
Lubricate with MoS2 grease
3 - Intermediate piece
4 - Dished washer
^
Small diameter (convex side) facing guide sleeve
5 - O-ring
^
Always replace
6 - Oil seal for input shaft
^
Available together with guide sleeve -item 7 - as one part
7 - Guide sleeve
^
Available together with oil seal -item 6 - as one part
^
Installation position: Oil drain hole facing downward
^
To protect oil seal -item 6 - place shrink down tube over input shaft splines
8 - Retaining spring
^
Attach to clutch release lever
9 - Internal TORX head bolt, 35 Nm
^
Self-locking Always replace
10 - Clutch release lever
^
Before installing lubricate locating recess for plunger of clutch slave cylinder with copper paste e.g. Z 381 351 TE
11 - Release bearing
^
With or without plastic ring, depending on design
^
Glue on detached plastic ring
^
Never wash out bearing; only wipe Replace noisy bearings Lock retaining tabs on release bearing in release lever
12 - Slave cylinder