A4 Quattro Wagon V6-3.0L (AVK) (2002)
-
Keep seal straight when installing. Drive in new oil seal for right flange shaft to a depth of 5.5 mm below outer surface of housing.
-
Fill space between sealing lip and dust lip with sealing grease G052 128 Al.
-
Keep seal straight when installing. Drive in new oil seal for left flange shaft to a depth of 5.5 mm below surface of cover.
-
Drive in flange shaft using mandrel VW 295.
-
Bolt drive shaft to flange shaft.
-
Install splash plates for drive shaft.
-
Check oil level in manual transmission.
Tightening torques