A4 Sedan V6-2.8L (AFC) (1996)
Flywheel: Service and Repair
REMOVAL
NOTE: Engine and transaxle removed.
1. Install crankshaft holder tool No. 3242, or equivalent, with crankshaft at Top Dead Center (TDC) position.
2. Mark relationship between flywheel and engine cylinder block (arrows).
3. Remove flywheel.
INSTALLATION
NOTE: The needle roller bearing is in the flywheel and must be pressed in when replacing the flywheel.
Reverse removal procedures to install, noting the following:
Tighten dual mass flywheel to: 40 Nm (30 ft. lbs.) plus 1/2-turn (180°).