A4 Sedan V6-3.2L (BKH) (2007)
Rear Bumper Cover / Fascia: Description and Operation
Side Impact Molding Centering Holes
Up to Vehicle Identification Number (VIN) 400 000
1 - Front bumper
‹› Position hole to vehicle outside - arrow B - according to marking on bumper.
‹› Position hole to vehicle center - arrow A - according to marking on bumper.
‹› If there is no marking in this position, the long hole (as depicted in illustration) must be manufactured at upper/outer edge, according to the lines
on bumper => [ Positioning centering holes ].
‹›
Positioning centering holes