A4 Sedan V6-3.2L (BKH) (2007)
Rear Door Panel: Service and Repair
Rear Door Trim, Removing and Installing
Rear Door Trim, Removing And Installing
1
-
Door trim
-
Removal:
-
Unclip decorative panel - 2 -.
-
Remove decorative panel - 2 - toward front.
-
Remove bolts - 3 - (3x) from door trim - 1 -.
Vehicles with electrical window regulators:
-
Power window switch, removing and installing.
Vehicles with manual window crank:
-
Remove and install manual window crank.
For all vehicles:
-
Unclip door trim - 1 -.
-
Replace damaged clips.
-
Raise door trim - 1 - upward approx. 20 cm out from door shell.
-
Disengage release for interior door mechanism.
-
Disconnect electrical harness connectors.
-
Remove rear door trim.
-
Installing:
Installation is reverse of removal. Observe the following when doing so:
When installing, speed nuts - 8 - (4x) for expanding nuts - 7 - (4x) must be clipped in.
When installing, door trim must be pressed in center toward door shell.
When installing manual window crank, note its position.
2
-
Trim panel
3
-
Bolt (Qty. 3)