A4 Sedan V6-3.2L (BKH) (2007)
-
Remove the side trim - 1 -.
‹› To replace the side trim - 1 -:
‹›
-
Remove anchorage point for outer floor assembly. Refer to => [ Outer Front Floor Assembly Anchorage Point ] See: Restraint Systems/Seat Belt
Systems/Service and Repair/Removal and Replacement.
‹› Installing
‹› After installing, make sure the seal is correctly pulled over the side trim.
‹›
-
Pull back on the clip - 6 - to release the tension on it - 6 -.
-
Install the side trim - 1 - in reverse order of removal.
2 - Clip
3 - Trim Panel
4 - Center Section
5 - Bolt
6 - Clip
7 - Clip
Trim Molding
-
Carefully pry off the trim - 1 - at the rear end in direction of - arrow -.
-
Unclip decorative panel - 1 -.
Insulation