A4 Sedan V6-3.2L (BKH) (2007)
/Page-1124001.png)
Catalytic Converter: Testing and Inspection
Three Way Catalytic Converter (TWC), Checking
Function test
-
Connect the scan tool.
-
Start the engine and let it run at idle.
-
Select "Diagnostic mode 6: Check test results of components that are not continuously monitored".
-
Select "Catalytic converter monitoring".
-
Select following Test-ID.
-
Check the specified values at idle.
-
End diagnosis and switch the ignition off.
If the specified values are exceeded:
-
Replace the catalytic converter with front exhaust pipe.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code.
-
End of diagnosis.
