A4 Sedan V6-3.2L (BKH) (2007)
Fluid - CVT: Service and Repair
Gear Oil Level In Front Final Drive, Checking
Gear oil level in front final drive, checking - 01J, Continuously Variable Transmission (CVT)
Note:
^
The specified oil level must be maintained exactly; the transmission reacts very sensitively to over-filling.
Test sequence
-
Take vehicle for a short test drive to heat gear oil to approx. 60 ° C.
-
Move vehicle onto a lifting platform or over a work pit so that it is absolutely level.
-
Switch off engine and allow 5 minutes for gear oil to settle back into transmission case.
-
Loosen quick-release screws -2- and -3- and remove rear noise insulation.
-
If installed, remove bolt -1- for noise insulation cover over left drive axle.
-
Disengage hook -2- and remove noise insulation cover.
-
Remove inspection plug -arrow-.
-
Check oil level using a tool created in the workshop, e.g. an angled section of wire.
^
Specified value: Oil level 8.5 mm below bottom of filler hole.