A4 Sedan V6-32L (BKH) (2007) Fuel Pressure Sensor | TSB | Page 4570
![background image](/audi/a4_sedan/v6-3.2l_(bkh)/Page-1438003.png)
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Engine Control Module/Service and
Repair/ECM, Removing and Installing.
-
Install the rear engine cover - arrows -.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes.
-
End of diagnosis.