A4 Sedan V6-3.2L (BKH) (2007)
If the specification was not obtained:
-
Replace the faulty Heated Oxygen Sensor (HO2S) behind the Three Way Catalytic Converter (TWC). Refer to Fuel Injection and Ignition Repair
Information.
If the specification was obtained:
Checking voltage supply
-
Switch the ignition on.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) electrical harness connector terminal 1 to
Engine Component Power Supply Relay (J757) terminal 2/87 for voltage.
-
Switch the ignition off.
Specified value: Battery voltage.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Ground (GND), or an open circuit.
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specification was obtained:
Checking Ground (GND) activation
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Engine Control Module/Service and
Repair/ECM, Removing and Installing.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) electrical harness connector terminal 2 to the
Engine Control Module (ECM) (J623) electrical harness connector T94 for an open circuit.