A4 Sedan V6-3.2L (BKH) (2007)
![background image](/audi/a4_sedan/v6-3.2l_(bkh)/Page-1687001.png)
Control Module: Service and Repair
01J Transmission
Transmission Control Module
‹› Observe general repair information. Refer to => [ General Repair Information ] See: Transmission and Drivetrain/Continuously Variable
Transmission/Transaxle/Service and Repair/Procedures/01J Transmission/General Repair Information.
‹› Rules of cleanliness for working on transmissions. Refer to => [ Clean Working Conditions ] See: Transmission and Drivetrain/Continuously
Variable Transmission/Transaxle/Service Precautions/01J Transmission/Clean Working Conditions.
Removing
The Transmission Control Module (TCM) (J217) can be removed with the transmission installed.
-
Remove the end cover. Refer to => [ End Cover, with Transmission Removed ] See: Transmission and Drivetrain/Continuously Variable
Transmission/Transaxle/Service and Repair/Removal and Replacement/01J Transmission/End Cover, With Transmission Removed.
-
Remove bolts - arrows - and pull out the Transmission Control Module (TCM) (J217) without tilting it.
-
Remove the twin lip oil seal - A - from the TCM.
‹› When positioning the TCM, ensure the sensor on the control module is not damaged.
Installing
Install in the reverse order of removal, note the following:
‹› Replace gaskets and O-rings.
-
If necessary, clean the sensors - A -, - C - and - D - of contamination and metal shavings.