A4 Sedan V6-3.2L (BKH) (2007)
-
Open yellow retainer on yellow-blue connector - 9 - with a screwdriver and disconnect connector.
‹› Installing:
-
Install belt webbing rotated by 180° - arrow - -as shown in illustration-.
-
Arrow - A - faces in direction of travel.
-
Ensure connector - 9 - is engaged correctly.
-
Remaining installation is in reversed sequence.
‹› After installing passenger side three-point seatbelt, check belt function for child seat. Refer to => [ Child Seat Anchorage, Checking Function ]
See: Repairs and Inspections Required After a Collision/Service and Repair/Seat Belts, Inspecting.
‹› The three-point seat belt must not be impeded by cables, wires, insulation, etc.
‹› Follow measures after connecting battery.
2
Outer Seat Belt End Anchorage Point Eyelets
3
Belt Tensioner
4
Bolt
‹› Tightening specification 55 Nm
5
Guide
6
Belt Height Adjustment
‹› Removal:
-
Remove upper B-pillar trim - 5 -. Refer to => [ Upper B-Pillar Trim ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal
and Replacement/Trim.
-
Remove bolt - 7 - and bolt - 8 -.
-
Remove belt height adjuster - 6 - upward.
‹› Installing:
To install, perform the steps used in removal in reverse order.
‹› Button - 10 - must not be pressed during installation.
‹› Function test after installing trim:
‹› Height adjuster must audibly engage into all five possible positions (even top position).
‹› Button must return by itself to upper position after being actuated.
7
Bolt
‹› Tightening specification 55 Nm
‹› Belt relay must swing by itself in carrier direction after tightening screw.
8
Bolt
‹› Tightening specification 23 Nm
9
Connector
10
Height Adjustment Button