A4 Sedan V6-3.2L (BKH) (2007)
‹› Removal - sedan:
-
Remove upper C-pillar trim. Refer to => [ C-Pillar Trim ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal and
Replacement/Trim.
-
Remove the rear shelf. Refer to => [ Rear Shelf ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal and
Replacement/Trim.
-
Remove insulation part under rear shelf.
-
Remove luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim ] See: Body and Frame/Interior Moulding / Trim/Service
and Repair/Removal and Replacement/Trim.
‹› Removal - Avant:
-
Remove luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim ] .
‹› All:
-
Remove bolt - 2 - on belt module/belt tensioner - 1 - from luggage compartment from below.
-
Loosen bolt - 5 - on outer seat anchorage point (eyes on end of belt).
-
To disconnect harness connector - 7 -, open retainer using a screwdriver (USA).
-
Loosen cable with clip.
‹› Installing:
-
When installing belt module - 1 -, ensure bolt - 2 - is in small diameter hole in retainer - 3 - both during and after tightening.
-
Ensure noise protection cap - 8 - on belt module - 1 - is seated correctly.
-
Ensure the belt tensioner wire - 4 - is clipped in and not in belt area.
-
Ensure connector - 7 - (USA) is engaged correctly.
-
Perform further installation in sequence opposite of removal.
2
Bolt
‹› Tightening specification 55 Nm
3
Belt Module/Belt Tensioner Locking Holes
4
Belt Tensioner Cable with Clip
5
Bolt
‹› Tightening specification 55 Nm
6
Seat Belt
7
Belt Tensioner Connector
8
Noise Protection Cap