A4 Sedan V6-3.2L (BKH) (2007)
Multiple Junction Connector: Service and Repair
Connector Junction, Electronics Box In Plenum Chamber, Removing and Installing
Connector Junction, Electronics Box In Plenum Chamber, Removing And Installing
Removing
-
Disconnect battery. Audi A4 S4. Audi RS4.
-
Where applicable, remove drivers storage compartment.
-
Remove electrical wire at bottom of connector point in plenum chamber electronics box.
-
Remove rubber seal of plenum chamber cover in direction of - arrow - .
-
Remove plenum chamber cover - 1 - to front.
-
Use screwdriver to pry off the two caps - 3 - .
-
Loosen nuts - 4 - (no not remove).
-
Remove wiper arms - 2 - from wiper shaft by tilting slightly.
-
Remove nuts completely and remove wiper arms.
-
Pull off retaining clips - 1 - and detach cowl panel grille - 5 -.
-
Remove cover for electronics box in plenum chamber - arrows - .