A4 Sedan V6-3.2L (BKH) (2007)
/Page-3247002.png)
CAUTION!
Safety goggles must be worn while drilling and sawing.
-
Drill a 3 mm diameter hole - arrow - through outer tube of shock absorber, or saw through side of tube.
Note:
^
Gas will escape when drilling or sawing.
-
Position pipe cutter (e.g. Stahlwille Express 150/3) as shown in illustration and cut through outer tube.
-
Pull piston rod upward, at the same time holding inner tube securely with pliers and pressing it downward, so that it remains in outer tube when
piston rod is slowly pulled upward.
-
Pull piston rod off inner tube.
-
Drain shock absorber tube.